Showing 49–64 of 346 results
-
AUTOMATIC POWER FACTOR CORRECTION USING PIC- MICROCONTROLLER
₹8,400.00₹7,500.00In this proposed system, two zero crossing detectors are used for detecting zero crossing of voltage and current. The project is designed to minimize penalty for industrial units using automatic power factor correction unit. The PIC microcontroller used in this project .
The time lag between the zero-voltage pulse and zero-current pulse is duly generated by suitable operational amplifier circuits in comparator mode is fed to two interrupt pins of a microcontroller. The program takes over to actuate appropriate number of relays from its output to bring shunt capacitors into load circuit to get the power factor till it reaches near unity.
-
Automatic power factor correction with measurement of real power ,reactive power, apparent power
₹9,600.00₹8,600.00Automatic Power Factor Correction with measurement of real power, reactive power, and apparent power. Two zero crossing detectors are used for detecting zero crossing of voltage and current.
-
AUTOMATIC SOLAR PANEL CLEANING ROBOT USING ARDUINO
₹14,800.00₹13,800.00The Solar energy is the most abundant source of energy for all the forms of Life on the planet Earth. Solar is the basic source of renewable energy. One can generally assume a reduction of about 40% – 55%, if the panels are not clean properly for 1-2 months.
-
Automatic Solar Pannel Cleaning By Sensing Solar Voltage And Light Luminance
₹11,000.00₹9,400.00The solar PV modules are generally employed in dusty environments. The dust gets accumulated on the front surface of the module and blocks the incident light from the sun. It reduces the power generation capacity of the module. The power output reduces as much as by 50% if the module is not cleaned for a month.
-
Automatic Star Delta Starter using Relays and Adjustable Electronic Timer for Induction Motor
₹6,800.00₹5,800.00The proposed project aims at providing low voltage to induction motors through star to delta conversion. Star Delta is basically used to lower the current rate applied to motor at start and after that full load current is applied.
-
Automatic Street Light Intensity Control Based On The IR Sensor Using Arduino
₹9,000.00₹7,800.00Nowadays the amount of power consumed by lighting and streets shares a major energy demand. The vehicles are passing over always and a part of places will be consisting of less dense areas and even no vehicle moments itself in few areas. But during the night all street lights will be on in a conventional street lighting system. To overcome this issue, proper energy-saving methods and lighting control are to be implemented.