Showing 49–64 of 374 results
-
AUTOMATIC IDENTIFICATION OF ELECTRICITY THEFT
₹10,400.00₹9,400.00In proposed system automatic identification of electricity theft using arduino. If we implement the project for a complete network of a area which will be consuming a very huge amount of energy. Here we are using arduino board, LCD display, current sensor, buzzer. And here in this project we can calculate the energy or power transmitted by the KEB and the energy consumed by the network of area. If both transmitted power by the KEB and the consumed power by the area differ by a large value the arduino will display these difference in the power reading on the LCD and the buzzer located in the KEB starts beeping indicating theft of electricity. As total Power losses equals transmission power losses plus distribution power losses.
-
AUTOMATIC IRRIGATION SYSTEM ON SENSING SOIL MOISTURE CONTENT
₹5,200.00₹3,500.00The project is designed to develop an automatic irrigation system that switches a pump motor on or off upon sensing the moisture content of the soil. In the field of agriculture, use of proper method of irrigation is important. The advantage of using this method is to reduce human intervention and still ensure proper irrigation.
-
Automatic Load Sharing By Parallel Transformer
₹7,500.00₹6,200.00Transformer is basically a static device which transfers the electrical power from one circuit to another circuit with desired change in voltage and current at constant frequency. It is only one device which operates at highest efficiency at full load condition. But abnormal condition occurs at overloading condition which may result in severe problem in future.
-
AUTOMATIC POWER FACTOR COMPENSATION FOR INDUSTRIAL POWER USE TO MINIMIZE PENALTY
₹8,700.00₹7,700.00The project is designed to minimize penalty for industrial units using automatic power factor correction unit. The micro-controller used in this project belongs to 8051 family. In this proposed system, two zero crossing detectors are used for detecting zero crossing of voltage and current.
-
AUTOMATIC POWER FACTOR CORRECTION USING PIC- MICROCONTROLLER
₹8,400.00₹7,500.00In this proposed system, two zero crossing detectors are used for detecting zero crossing of voltage and current. The project is designed to minimize penalty for industrial units using automatic power factor correction unit. The PIC microcontroller used in this project .
The time lag between the zero-voltage pulse and zero-current pulse is duly generated by suitable operational amplifier circuits in comparator mode is fed to two interrupt pins of a microcontroller. The program takes over to actuate appropriate number of relays from its output to bring shunt capacitors into load circuit to get the power factor till it reaches near unity.
-
Automatic power factor correction with measurement of real power ,reactive power, apparent power
₹9,600.00₹8,600.00Automatic Power Factor Correction with measurement of real power, reactive power, and apparent power. Two zero crossing detectors are used for detecting zero crossing of voltage and current.
-
AUTOMATIC SOLAR PANEL CLEANING ROBOT USING ARDUINO
₹14,800.00₹13,800.00The Solar energy is the most abundant source of energy for all the forms of Life on the planet Earth. Solar is the basic source of renewable energy. One can generally assume a reduction of about 40% – 55%, if the panels are not clean properly for 1-2 months.
-
Automatic Solar Pannel Cleaning By Sensing Solar Voltage And Light Luminance
₹11,000.00₹9,400.00The solar PV modules are generally employed in dusty environments. The dust gets accumulated on the front surface of the module and blocks the incident light from the sun. It reduces the power generation capacity of the module. The power output reduces as much as by 50% if the module is not cleaned for a month.
-
Automatic Star Delta Starter using Relays and Adjustable Electronic Timer for Induction Motor
₹6,800.00₹5,800.00The proposed project aims at providing low voltage to induction motors through star to delta conversion. Star Delta is basically used to lower the current rate applied to motor at start and after that full load current is applied.
