The objective of this project is to determine the distance of underground cable fault from base station in kilometers USING AN Arduino board. The underground cable system is a common practice followed in many urban areas. While a fault occurs for some reason, at that time the repairing process related to that particular cable is difficult due to not knowing the exact location of the cable fault. The proposed system is to find the exact location of the fault.
The project uses the standard concept of Ohms law i.e., when a low DC voltage is applied at the feeder end through a series resistor (Cable lines), then current would vary depending upon the location of fault in the cable. In case there is a short circuit (Line to Ground), the voltage across series resistors changes accordingly, which is then fed to inbuilt ADC of Arduino board to develop precise digital data for display in kilometers.
The project is assembled with a set of resistors representing cable length in KM’s and fault creation is made by a set of switches at every known KM to cross check the accuracy of the same. The fault occurring at a particular distance and the respective phase is displayed on a LCD interfaced to the Arduino board.
Further this project can be enhanced by using capacitor in an ac circuit to measure the impedance which can even locate the open circuited cable, unlike the short circuited fault only using resistors in DC circuit as followed in the above proposed project.
Underground cable fault detection using arduino is the project of the last year
engineering projects, BE final year engineering project. This project is use for the BE last
year and electronics department students use and electrical department students is use.
Underground cable fault detection using arduino this project for the good price for the
engineering projects. It is very comparative engineering project. It is very good BE final year
and Diploma projects. This project electronics departments as well as an electrical in final
year students is use. This project is arduino based underground cable fault detection project
for the last year engineering project for the electronics and electrical department students is
Underground cable fault detection using arduino is the project for the arduino based
for the good project, excellent project for the BE last year engineering student is use
for the core electronics student is use. This project for the competitive project in the
BE last year engineering student for electronics and electrical student in last year
engineering student in the use .
The engineering projects give in the ELECTROSAL HI- TECH PVT.LTD. The best place of
the degree and diploma final year engineering projects as well as for electronics student’s and
electrical final year for the golden opportunity.
Underground cable fault detection using arduino it is the best projects for the electronics
electrical , final year student is use and idea for the electronics and electrical degree and
diploma base students and 100% output is done.
- Under ground fault detection from base station
- using an Arduino
- Exact fault location of cable
- Used standard concept of Ohams law
- LCD Display
- Arduino C