Showing 49–64 of 360 results
-
AUTOMATIC IRRIGATION SYSTEM ON SENSING SOIL MOISTURE CONTENT
$62.50$42.07The project is designed to develop an automatic irrigation system that switches a pump motor on or off upon sensing the moisture content of the soil. In the field of agriculture, use of proper method of irrigation is important. The advantage of using this method is to reduce human intervention and still ensure proper irrigation.
-
Automatic Load Sharing By Parallel Transformer
$90.15$74.52Transformer is basically a static device which transfers the electrical power from one circuit to another circuit with desired change in voltage and current at constant frequency. It is only one device which operates at highest efficiency at full load condition. But abnormal condition occurs at overloading condition which may result in severe problem in future.
-
AUTOMATIC POWER FACTOR COMPENSATION FOR INDUSTRIAL POWER USE TO MINIMIZE PENALTY
$104.57$92.55The project is designed to minimize penalty for industrial units using automatic power factor correction unit. The micro-controller used in this project belongs to 8051 family. In this proposed system, two zero crossing detectors are used for detecting zero crossing of voltage and current.
-
AUTOMATIC POWER FACTOR CORRECTION USING ARDUINO
$106.98$94.96In this proposed system, two zero crossing detectors are used for detecting zero crossing of voltage and current. The project is designed to minimize penalty for industrial units using automatic power factor correction unit.
Select optionsThe product is already in the wishlist! Browse Wishlist -
AUTOMATIC POWER FACTOR CORRECTION USING PIC- MICROCONTROLLER
$100.97$90.15In this proposed system, two zero crossing detectors are used for detecting zero crossing of voltage and current. The project is designed to minimize penalty for industrial units using automatic power factor correction unit. The PIC microcontroller used in this project .
The time lag between the zero-voltage pulse and zero-current pulse is duly generated by suitable operational amplifier circuits in comparator mode is fed to two interrupt pins of a microcontroller. The program takes over to actuate appropriate number of relays from its output to bring shunt capacitors into load circuit to get the power factor till it reaches near unity.
-
Automatic power factor correction with measurement of real power ,reactive power, apparent power
$115.39$103.37Automatic Power Factor Correction with measurement of real power, reactive power, and apparent power. Two zero crossing detectors are used for detecting zero crossing of voltage and current.
-
AUTOMATIC SOLAR PANEL CLEANING ROBOT USING ARDUINO
$177.90$165.88The Solar energy is the most abundant source of energy for all the forms of Life on the planet Earth. Solar is the basic source of renewable energy. One can generally assume a reduction of about 40% – 55%, if the panels are not clean properly for 1-2 months.
Select optionsThe product is already in the wishlist! Browse Wishlist -
Automatic Solar Pannel Cleaning By Sensing Solar Voltage And Light Luminance
$132.22$112.99The solar PV modules are generally employed in dusty environments. The dust gets accumulated on the front surface of the module and blocks the incident light from the sun. It reduces the power generation capacity of the module. The power output reduces as much as by 50% if the module is not cleaned for a month.
-
Automatic Star Delta Starter using Relays and Adjustable Electronic Timer for Induction Motor
$81.74$69.72The proposed project aims at providing low voltage to induction motors through star to delta conversion. Star Delta is basically used to lower the current rate applied to motor at start and after that full load current is applied.
-
Automatic Street Light Intensity Control Based On The IR Sensor Using Arduino
$108.18$93.76Nowadays the amount of power consumed by lighting and streets shares a major energy demand. The vehicles are passing over always and a part of places will be consisting of less dense areas and even no vehicle moments itself in few areas. But during the night all street lights will be on in a conventional street lighting system. To overcome this issue, proper energy-saving methods and lighting control are to be implemented.
